Clean vs No-Clean Fluxes
Posted on: September 18 2013, 0 Comments
Question: We are using a Kester 186 RMA Flux for our assembly process. Can you tell me if you have to clean an RMA flux and what the issues are if we do not?
Question: We are using a Kester 186 RMA Flux for our assembly process. Can you tell me if you have to clean an RMA flux and what the issues are if we do not?
Question: We are attempting to hand solder through hole components in a very thick board, but are finding that the solder does not flow through to the other side of the board. Is there a method or technique I need to use to accomplish this?
Clean vs No-Clean Fluxes Posted on September 18, 2013
Through Hole Soldering of Thick PCBs Posted on September 18, 2013